Hey there, folks! Welcome back to the show. If you're new here, I'm Paul. Today, I'm excited to walk you through a quick 10-minute tutorial on rat guard installation. Rat guard, as you may know, is the trim at the bottom of your building where your Wayne's coating sits. While it may seem straightforward, getting it just right can be a bit tricky. But fear not, I've spent some time figuring out the best techniques, especially when dealing with outside corners and open-ended setups like between garage doors. So, let's dive in!
Rat Guard End Finishes:
When it comes to installing rat guard, precision is key. Start by making a cut about an inch from where the trim will end, leaving you with the necessary extra inch to fold over and conceal any gaps. Measure twice, cut once! Once you've got the length sorted, mark the top and bottom, and make your cuts accordingly. Now, here's where the magic happens. Use fenders to ensure a clean bend at a 90-degree angle, making sure it fits snugly into the hem. A little hammer persuasion might be needed here. And for that added security, consider using a color-matched rivet to keep it in place.
Rat Guard Corner Finishes:
Now, let's talk corners. For an outside corner, leave one piece of rat guard to extend about an inch past, then 45 the top and bottom back to this corner. Don't worry too much about exact measurements; sometimes, a good eye is all you need! Once cut, mark about an inch from the corner, make an angled cut, and bend that little piece up at a 45-degree angle. This will neatly tuck into the hem of the other piece, giving it a polished finish.
Conclusion:
And there you have it, folks! With these techniques, you'll be a rat guard installation pro in no time. I hope you found this tutorial helpful and that it brings you one step closer to mastering your DIY projects. Remember, precision and patience are your best friends when it comes to home improvement. If you want to dive deeper into the world of post-frame building or home design, be sure to check out our website, mrpostframe.com, for design help and our Patreon for exclusive self-built topics discussions.
Thanks for tuning in, and until next time, happy building! Don't forget to hit that subscribe button for more tips and tricks.
Thank you,
MR Post Frame
Patreon Group:
Interested in tackling your build on your own? If you want to explore the possibility of being your GC or self-building, our Patreon membership is for you! It's a community of like-minded people offering support, discounts, Q/A, and more.